Boat with DC Motor and Arduino- Prepping to glue on pieces

Boat with DC Motors and Arduino 

What was the Most Important Thing?

In order for our boat to function, we just need to run a code because it is very important for the motors to run the propellers. We have accomplished putting it together now are last and final step is figuring out if we need a control remote to control the boat or have a code that controls the directions.

Project Page - Still working on it

Team members: Chelsea Cortez, Melanny Valencia

What Steps Did We Solve:

1. Cut the white foam- Done - 
2. Cut the black board Done
3. Saughter the motors with the cables and glue them into the bottle Done
4. Drill holes to put the propeller  Done
5. Drill holes to put screw for Arduino Done
6. Cut the foam so the black board fits perfectly in Done
7. Glue On Board Done
8. Run the code Done
9. Run the code Done

Next Steps:

 "Pending", "In Progress", "Road Block", "Done"

1. Figure out if we need a control- Pending
2. Try it on water- Pending

SHAREABLE LINK TO OUR PRESENTATION:

https://docs.google.com/presentation/d/1rLRetv9s6MTkzVnINl4-Ho77aHbyVGmTqUGKPkckt7g/edit?usp=sharing